Bus Converter

From ATLauncher Wiki
Jump to: navigation, search
Bus Converter
Bus Converter

Name Bus Converter
Source Mod Project Red
ID Name
?
Type Item
Stackable Yes (64)

The Bus Converter, is a bundled logic gate with 4 inputs and 2 outputs, primarily used to convert analog redstone signals (i.e. signals of strength 0-15) to and from their corresponding digital signals (bundled cable colors).

I/O

The Bus Converter at any given time has a total of 3 outputs and 1 input. When placed on the ground, the left and right sides of the gate are the 2 running outputs. The front is the bundled connection, while the back is the analog connection. Depending on the mode, the front is the input and the back is the output, or vice versa. The bundled connection can only connect to Bundled Cable.

Logic

The purpose of the bus converter is to change analog redstone signal levels to and from their respected color on the bundled cable spectrum. Signals 0 to 15 are equivalent to colors white to black (i.e. 0 to white, 1 to orange, etc.)

Analog to Digital

By default, the gate is in Analog to Digital mode, which means it will look at the current level of analog signal at its analog input and output the corresponding color on the bundled output in the front of the gate. When the analog input is non-zero, the two running outputs are enabled as well. Note that when there is a zero analog signal as the input, the color white will be enabled. Therefore, there is always at least 1 color being emitted at all times.

Digital to Analog

The second mode is Digital to Analog, in which the gate will take the highest color at the bundled input, and convert it to the corresponding analog output. When the bundled input signal is non-zero, the two running outputs are enabled as well. Note that when the white color is enabled in the bundled input, the output is still zero. That means there is no way to differentiate between a zero bundled input from a white bundled input. This is when the running outputs are handy.

Configuration

A shift-right-click with a screwdriver can swap the conversion modes.

Any issues pertaining to "Bus Converter" are maintained on the ProjectRed Github page. Report issues there.

Recipe[edit]

GUI Crafting Table.png
Circuit Plate
Bundled Plate
Circuit Plate
Conductive Plate
Silicon Chip (Project Red)
Conductive Plate
Circuit Plate
Conductive Plate
Circuit Plate
Bus Input Panel

Usage[edit]

Bus Converter has no known uses in crafting.